Connecting And Grounding - Phocos CIS-N-LED Serie Manual De Instrucciones

The product is CE compliant.

Connecting and Grounding

Connect wires in the order as indicated in the system drawing 1, 2, 3, 4, 5, 6, 7 to avoid

installation faults
To avoid any voltage on the wires, first connect the wire to the controller, then to the

battery, panel or load
Make sure the wire length between battery and controller is as short as possible

Maximum cable length from charge controller to LEDs: < 2m

Be aware that the negative terminals of CIS-N-LED are connected together and therefore

have the same electrical potential. If any grounding is required, always do this on the negative
wires
19