Publicidad
Idiomas disponibles
Idiomas disponibles
6 Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Switching the paper shredder on
• Press rocker switch
Rocker switch locks in place.
Green LED lights.
Paper shredder is ready for op-
eration (standby).
Feed paper
• Insert the paper to be de-
stroyed. See "Technical data"
for sheet capacity.
Automatic start stop control
starts the cutting system auto-
matically.
Paper is pulled into cutting
system and shredded.
When the paper fee ding opening is free
again, the cut ting sy stem au to ma tical ly swit-
ches off af ter app rox. 3 sec. and returns to
standby.
Shredding CDs and disks (see "Prop-
er Use")
Swit ching paper shredder off
• Tap rocker switch
Switch returns to ze ro po si ti on.
12
.
Feed CDs and disks
through the slot in the
safety element. This
protects you from splin-
ters.
.
7 Troubleshooting
Paper jam
You have fed in too much paper.
Notice
Do not press rocker switch alter-
nately forwards/backwards (
unit could be damaged.
• Press rocker switch
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed in pa per successively.
Shredded material container full
Red LED lights.
Paper shredder switches off.
Notice
Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Switch equipment off. To do this
tap rocker switch
• Remove full shredded material
bag and insert new bag.
Door open
Red LED lights.
Paper shredder switches off.
• Check whether front door is
closed properly.
For all other malfunctions, before calling
customer service please check
– if the motor was overloaded
Let the shredder cool down for approx.
15 – 20 mins. before using it again.
– if the light barrier is soiled with paper
dust.
Clean the light barrier in the paper feed
using a dry brush or cloth.
Classic 125.2
english
-
). Cutting
.
.
.
09/2011
Publicidad
