COMPANION 320.10831 Manual Del Operador página 9

INSTALLING THE SAW BLADE cont.
4. Remove the saw blade from the spindle,the innerbushing remained on spindle.
5. Clean the flange thoroughlybefore mountingthe new saw btade.
6. Mount the new saw blade and tightenthe hexagonblade scTew. C heck to be sure
the blade runs freely by turningthe blade by hand.
Note: The directionin whichthe blade rotateshas to be the same as the diredion
of the arrow marked onthe guard.
7. Be sure Ihatthe spindleieck buttonIs released.
8. Make sure the saw is in good workingorder beforeusingif again.
TRIGGER SWITCH WITH =LOCK-OFF" BurToN
The toolcan only be activatedwhen both trigger and lock-offtxdlon are depressed
tngether.The main switchcan also be locked in the "OFF'position to help
prevent accidents.
A_ WARNING: Alwaysensure that the saw is switchedoff and unplugged
formthe power supplybeforemakingany adjustmenla.
ADJUSTING THE CU'I'/'ING DEPTH
1. Loosen the depth lockinglever
as shown in Fig.5.
2. Hold the base plate flatagainst the
edge of the workpiece and 1illthe
body of the saw untilthe blade is at
the desiredcuttingdepth. The saw
teeth mustproject2 mm out
of the wood.
3. Tighten the depth iecking lever.
FIG. 5
ADJUSTING THE CUI'RNG ANGLE
1. Loosen the angle lockingknob
locatedon the 0°- 45° bevel gauge
which is on the base plate,
2. Till the body ofthe saw (F3g.6) until
the required angle Is reached by
usingthe scale on the 0°- 45°
bevel gauge.
3. Tighten the Iociengknob to secure
the base plate.
FIG. 6