Publicidad
Idiomas disponibles
Idiomas disponibles
4
English
English
This document describes how to upgrade
the MPC-2610 firmware to the latest version.
The version upgrade data is first saved to an
SD card and then the unit is upgraded using
the menu.
For details about menu operation, refer to the
Operating Instructions.
Preparation
Checking the Existing Version
Select Version in the Maintenance menu of the
full menu to display the Version Number item.
Notes About Version Upgrade
ˎ Always connect an AC adaptor (for example,
ˎ
AC-DN10A) when upgrading. If a battery
pack is attached at the same time, the
upgrade will continue if the AC adaptor is
subsequently disconnected.
ˎ Disconnect all devices (such as USB devices,
ˎ
SDI, HDMI, microphone, shoe accessories)
connected to the unit and remove any
memory card inserted in the CFexpress Type
B card slot before starting the upgrade.
ˎ Use an SD/SDHC/SDXC memory card for the
ˎ
SD card in the following description.
ˎ Use an SD card that has been formatted
ˎ
using the formatting function of the unit.
For details about the formatting function, refer to the
Operating Instructions.
Saving Version Upgrade Data to
an SD Card
1
Mount the formatted SD card on a
computer.
2
Download the version upgrade data ZIP file
from the version upgrade data download
site, and save the data on your computer.
3
Uncompress the ZIP file to retrieve the
version upgrade data (BODYDATA.DAT) and
save the data in the root directory of the
SD card.
Upgrading the Firmware
Version
[Note]
Do not perform any of the following operations while
upgrading the firmware. The version upgrade will not be
completed, and could cause the unit to malfunction.
ˎ Removing/inserting the SD card
ˎ
ˎ Turning the unit off
ˎ
For details about unit operation, refer to the Operating
Instructions.
1
Insert the SD card on which the version
upgrade data was saved into the Utility SD
card slot of the unit.
2
Select Version > Version Up in the
Maintenance menu of the full menu, and
select Execute.
The following message appears.
"Please use the AC adapter"
"Upgrade Version?"
3
Select Execute.
A "Version Upgrade VX.XX > VY.YY"
message appears (X.XX: existing version
number, Y.YY: latest version number).
If the version upgrade data cannot be
determined, a "Version Upgrade No File"
message appears. Check the following
possible causes.
ˎ The version upgrade data was not saved
ˎ
in the root directory of the SD card.
ˎ The version upgrade data for a different
ˎ
model was saved.
ˎ The version could not be decoded
ˎ
successfully.
Save the correct version upgrade data on
the SD card, and then perform the upgrade
procedure again from step 1.
EN
Publicidad
