Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Selection of Installation Equipment
• Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole. Be sure
the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work surface
material (Wood and similar fibrous or hygroscopic material shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop should be
at least 3mm.
A(mm)
B(mm)
268(+4/- 0 )
490(+4/-0)
• The ceramic cooker hob can be used on the table top of cabinet. The ceramic hob should be placed horizontally.
As shown below:
50mm min
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet are
not blocked. Ensure the ceramic cooker hob is in good work state. As shown below.
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least
760mm.
A
C
D
C(mm)
50 min
A
A
B
F
E
D(mm)
E(mm)
50 min
50 min
11
SEAL
G
Min.3mm
F(mm)
50 min
B
B
50mm min
G(mm)
3 min
V.1
Publicidad
