Descargar Imprimir esta página

Garland 718-V20 Manual De Instrucciones página 50

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
English
inclination of the tree, its width and its branches, as
this could affect the direction in which the tree falls.
2. Check there are no other trees, branches or
obstacles which could be in the way of the tree
when it falls.
3. Check the position in which the tree will be once it
has fallen, in order to ba able to embark on the
cutting tasks.
5. Remove the first branches. Firstly remove the
lower branches which make the task more difficult.
Remember that you must never cut the branches
that are above shoulder height. Remember to never
stand directly behind the tool.
6. Make a guiding cut (B) in the shape of a wedge,
the size of a quarter of the width of the tree (1/4d)
on the side on where you want the tree to fall (E).
To do this, make a top cut of 60º and a bottom cut
of 35º. This will ensure the two cuts will form an
angle of 90º, it is important that the two cuts
make a perfect joint, so they can act as a hinge in
the appropriate direction of the fall.
Suggestion: Before going on to the next step add fuel
4. Clear the area
around the tree.
and chain oil, in order to ensure the tool does not stop
Make sure you are
unexpectedly during the tasks that follow.
going to work in a
stable position and
7. Start the felling cut (C) from the opposite side to
establish an easy
and clear escape
which allows you
to run away if
8. When you have cut a quarter of the tree, stop the
the tree falls in
an unexpected
direction.
The safety distance
must be equivalent
to at least two
9. Continue with the felling cut (C) until you are within
lengths of the tree.
10.The tree will fall in the direction of the guiding
If it does not fall, use the wedge in order to force the
tree to fall.
As soon as the tree starts to fall, back away diagonally
from the tree, in order to be at a safe distance when
the tree touches the ground. It is important to keep
away because when it touches the ground, you could
be hurt by branches and splinters flying around or by
roots from the ground.
50/172
the guiding cut and at a slightly higher level (3cm)
than the bottom of the guiding cut (B).
tool and introduce a felling wedge (A) in order to
avoid the tree leaning backwards and trapping
the tool or causing the tree to fall in an unwanted
direction.
3 cm of the guiding cut. This part of the wood is
left uncut, so it can act as a hinge and direct the
trunk towards the desired place.
cut "E".

Publicidad

loading

Este manual también es adecuado para:

Montana 718