Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
• Measure the distance between the
mounting holes (H) and drill the
holes.
• Insert the dowels (included in the
package contents).
• Thread the power supply cable(s)
through the cable inlet of the
mounting plate.
The sheath insulation should be
inserted at least 5 mm into the
device to ensure the water-tight-
ness of the device.
Figure 8
• Position the mounting plate with
the "TOP" mark and the arrow
pointing upwards at a suitable
point on a wall.
• Place the wall mounting bracket
over the holes. Use the screws sup-
plied to attach the mount to the
wall.
2x
2x
Figure 9
Never open several inlets without
inserting a suitable cable into
them, as otherwise the IP protec-
tion classification against the in-
gress of water and solids is not
satisfied.
• Connect the device as shown in
the connection diagram.
• To do this, connect the supply
wires to the terminals of the mo-
tion detector as shown in the fig-
ure.
• Snap the terminals into the desig-
nated positions on the mounting
plate.
N
L
1
Figure 10
L
N
PE
26
Publicidad
