Fuse Check/Replacement; Safety Functions; Emergency Push-Button; Speed Reduction At Bends - Clarke CR 28 BOOST Libro De Instrucciones

FUSE CHECK/REPLACEMENT

1. Turn the ignition key (42) to "0".
2. Remove the nuts (E, Fig. 7), then remove the cover (A).
3. Check and, if necessary, replace the following fuses:
B. Low power circuit protection fuse (F3): (5 A)
C. Drive system electronic board protection fuse (F2): (60 A)
D. Function electronic board protection fuse (F1): (100 A)
4. Install the cover and tighten the nuts.

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.

EMERGENCY PUSH-BUTTON

It is located in a position (32) that is easily accessible for the operator. Press it in case of immediate necessity to stop all machine
functions.
To reset it, turn it clockwise.

SPEED REDUCTION AT BENDS

It reduces the machine speed in case of bends exceeding a specifi ed angle.

DRIVER SEAT MICROSWITCH

It is inside the driver's seat and it prevents the drive system operation when the operator is not on the driver's seat.

ELECTROMAGNETIC BRAKE

Built-in the front wheel, it keeps the machine stopped when: the machine is off, when the emergency stop button is pushed and
when the drive pedal is not pressed.
Figure 7
Operator's Manual - CR 28 BOOST®
ENGLISH
S311214A
23