Main Features - BS Charger BS60 Manual De Instrucciones

IMPORTANT SAFETY ADVICE AND WARNINGS

The charger is designed to charge and maintain 12V batteries AGM & WET, CALCIUM and GEL
 Always refer to the battery manufacturer's specifications and recommendations if you're unsure of your battery charging requirements.
E.g. such as removing or not removing cell caps whilst charging, battery type, maximum charge rate etc...

Explosive gases may escape from the battery during charging so please ensure the battery is being charged in a well-ventilated area.

This charger is designed for indoor use only and should never be exposed to water, rain, snow, liquids etc.

Do not attempt to use the charger if it has been dropped or damaged.

Do not attempt to use the charger if the cables or plugs are damaged.

If battery acid contacts your skin or clothing, wash immediately with soap and water. If acid enters your eye, immediately flush the
eye with running cold water for at least 10 minutes and seek medical attention. Someone should always be within range of your voice.

Never attempt to charge a damaged battery, frozen battery or non-rechargeable battery.

Never put the charger on the battery or battery on the charger.

When working with lead-acid batteries, remove personal metal items such as rings, bracelets, necklaces, watches and make sure you
don't short circuit the battery terminals with any type of metal tool as this will cause an explosion. You can wrap your spanner with
insulation tape to minimize the risk of a short circuit.

NEVER smoke, use an open flame or create sparks near a battery or charger during charging operation as this may cause an explosion
and explosive gases.

Do not disassemble the charger. Take it to a qualified and authorized person for repair.

If using a generator, you must ensure you use a surge protector to protect the charger from voltage spikes.

The charger must not be used or played with by infirm persons or children. Also keep it away from any pets.

MAIN FEATURES


100% automatic smart battery charger & maintainer with reconditioning function.

The battery charger is easy to use and requires no technical experience.

Fully microprocessor controlled with safety timers at every stage.

Battery condition analysis.

Selectable battery type.

Selectable charge rate / mode.

Patented battery rejuvenation (reconditioning).

Battery voltage retention analysis.

Pulse charge for long term maintenance.

Ultra low power consumption (ECO Mode)

Multi Stage:
1 - Qualification - Battery condition check
2 - Battery rejuvenation (reconditioning mode)
3 - Soft start charging
4 - Bulk charging
5 - Absorption charging
6 - Equalization charging
7 - Battery analysis
8 - Float mode
9 - Long term maintenance pulse charge

Automatic diagnosis and charge: On power-up, the charger will automatically diagnose the battery condition and determine if the
rejuvenation (reconditioning mode) or charge cycle is required.

Patented battery rejuvenation technology: the charger has a unique and patented rejuvenation feature which uses high voltage
equalizing and peak pulse reconditioning to repair sulphated batteries. This feature is fully automatic and depends on the internal
impedance of the battery.

Can be left on 24/7 to ensure your battery is always maintained and fully charged: The battery charger can be left unattended and
left permanently connected all year round. The intelligent charger will monitor the battery voltage and will maintain it at peak
performance with a special pulse charge during long term maintenance.

Short circuit and reverse polarity protection:

Heavy-duty and corrosion-resistant output connectors:

Crocodile clips: It comes with a quick connect fly lead and heavy duty, fully insulated crocodile clips.

Rapid Charge Mode: uses maximum charging current to ensure the fastest
charge time. You may here have the fan turned on during this mode.

Silent Charge Mode: charges at a slightly reduced charge rate so the cooling
fan is not required.

Maintenance Mode: ideal and recommended for long term maintenance
charging or charging of smaller batteries.
P.2