Troubleshooting - BS Charger BS60 Manual De Instrucciones

CHARGING CURVE
TROUBLE SHOOTING
Problem Indication
Charger does not No Indicator
work? lights on
Charger has no DC Error Red LED
output? is ON
No charging Error Red LED
current? is Flashing
The full / float light Error Red LED
won't come on.
is Flashing
or
Full Charge
Green LED is
Flashing
Possible Causes
- No AC power
- Output is short circuited
- Reverse polarity protection
- Loose / bad connection to the
battery
- Battery is severely sulphated
- Battery has a damaged cell
- Overheat protection mode
- Battery Ah capacity too large for the
battery charger and it has time out
- Battery is defective
- Battery is severely sulphated
Suggested Solution
- Check AC connections and make sure the AC
Power supply is switched ON.
- Try a different AC Power supply which you know is
working.
- Check DC connections between charger and battery
and make sure they are not short circuited. (Touching
each other)
- Check that the crocodile clips have not fallen off or
come loose.
- Check that the crocodile clips/ ring terminals are
connected with the correct polarity.
Note: The charger output current is only present
when connected to a battery.
- Check the battery condition, age etc.
- Battery may need replacement.
- Move battery & charger to a cooler environment.
- Check that the charger specifications match the battery
capacity. E.g. make sure that the battery capacity is not
too big for the charger
- Battery may need replacement.
- The selected charge rate might be too low for the
battery. Switch charger off and on and try again or try
a higher charge rate setting. Make sure it doesn't
exceed the maximum charge limit for your battery.
P.6