BS Charger BS60 Manual De Instrucciones página 5

STEP 4 - Disconnecting the Battery charger from Battery
If the Battery is out of the vehicle:
(1) Switch OFF and Remove the AC Power Socket from the outlet.
(2) Remove the Black lead and then the Red lead.
If the battery is still in the vehicle:
(1) Switch OFF and Remove the AC Power Socket from the outlet.
(2) Remove the lead from the vehicle chassis.
(3) Remove the lead from the battery.
Note: Check electrolyte levels if possible after charging as they may need topping up with distilled water. (This does not apply to sealed
maintenance free batteries)
LED STATUS INDICATOR TABLE:
LED
Battery Type LED's
Green
Charge Rate LED's
Green
Charging Status LED's
Full Charge Green
Absorption. Green
Bulk Blue
Error LED
Red
Red
Status Description
ON Indicates which Battery Type is selected
ON Indicates which Charge Rate / Charge Mode is selected
Flash/ON Flashing if Analysis failed or ON if fully charged - Float /
Maintenance mode
Flash/ON Flashing during equalization charging or ON during Absorption
charging
Flash/ON Fast Flash - Rejuvenation / Slow Flash - Soft Start charging / ON
- Bulk charging
ON Short circuit/reverse polarity or Rejuvenation failed if Bulk LED
also flashing slow
Flashing Over temperature protection mode / Soft start charging timed out
if Blue Bulk LED also flashing fast / Bulk charging timed out if
Blue Bulk LED also ON
P.5