HT Italia HP03010C Manual De Instrucciones página 42

6. MAINTENANCE
6.1. GENERAL INFORMATION
1. While using and storing the instrument, carefully observe the recommendations listed
in this manual in order to prevent possible damage or danger during use.
2. Do not use the instrument in environments with high humidity levels or high
temperatures. Do not expose to direct sunlight.
3. Always switch off the instrument after use. In case the instrument is not to be used for a
long time, remove the battery to avoid liquid leaks that could damage the instruments
internal circuits.
6.2. REPLACING THE BATTERY
When the LCD display shows the symbol "
Only expert technicians should perform this operation. Before carrying out
this operation, make sure you have removed all cables from the input
terminals or the cable being tested from inside the clamp jaw.
1. Turn the rotary switch to the OFF
2. Disconnect the cables from the input terminals and the cable being tested from the
clamp jaw.
3. Loosen the battery cover fastening screw and remove the cover.
4. Remove the batteries and replace with new of the same type (see § 7.1.2) paying
attention to correct polarity.
5. Position the battery cover back over the compartment and fasten it with the relevant
screw.
6. Do not scatter old batteries into the environment. Use the relevant containers for
battery disposal.
6.3. CLEANING THE INSTRUMENT
Use a soft and dry cloth to clean the instrument. Never use wet cloths, solvents, water, etc.
6.4. END OF LIFE
CAUTION: this symbol found on the instrument indicates that the appliance, its
accessories and the battery must be collected separately and correctly disposed
of.
", it is necessary to replace the batteries.
CAUTION
EN – 17
HT3013