Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the blade screw (17) and the washer.
4. Re-install the new blade (16) in reverse order. Fas-
ten the blade screw (17) properly. Ensure that the
blade (16) is correctly positioned in the fastening
pins and lies flush.
5. The tightening torque of the blade screw (17) is
45Nm. Also replace the blade screw (17) when re-
placing the blade (16).
11.2.2
Damaged blade (16) (Fig. 11)
If the blade (16) has come into contact with an obsta-
cle:
• Switch off the motor, wait for it to stop, remove the
battery and pull out the safety key.
• Check the blade (16) for damage.
• Damaged or bent blades (16) must be replaced.
• Never attempt to bend a bent blade (16) back to
straight again.
• Never mow the lawn with a bent or heavily worn
blade (16) as this will cause vibrations and can lead
to further damage to the lawnmower.
12 Storage and transport
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
12.1
Fold the upper push bar (1)
together (Fig. 1)
WARNING
Risk of jamming!
Always hold the push bar with one hand at the high-
est point.
–
Never place fingers between the upper push bar
and the lower push bar.
For space-saving storage, the upper push bar (1) is
foldable.
1. Remove the grass collection basket (5).
2. Loosen the locking nuts (2) on the upper push bar
(1).
3. Move the upper push bar (1) down. The cable (9)
must not be pinched in the process.
12.2
Preparation for storage
1. Remove the battery.
2. Empty the product completely.
3. Clean and check the product for damage.
13 Repair & ordering spare parts
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
ATTENTION
According to the German Product Liability Act, no lia-
bility is accepted for damage caused by improper re-
pairs or by not using original spare parts.
Such work should be performed by a customer ser-
vice centre or an authorised specialists. The same
applies to accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
13.1
Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Battery GO-ABP 2.0 item no.:
Battery GO-ABP 4.0 item no.:
Battery charger GO-BC 2.4 item no.:
Battery charger GO-BC 4.5 item no.:
Battery charger GO-BC 2.4 twin item
no.:
Battery charger GO-BC 4.5 twin item
no.:
StarterKit GO-SK2.0 item no.:
StarterKit GO-SK4.0 item no.:
Blade - Article no.:
Blade screw - Article no.:
www.scheppach.com
7909201714
7909201715
7909201716
7909201717
7909201718
7909201719
7909201725
7909201726
7911200649
5911413001
GB | 33
Publicidad
