Extension Table; Detaching The Tabte; Attaching The Table; Accessory Box - Sears Kenmore 385.15108200 Manual De Instrucciones

Tabla de contenido

Publicidad

Extension
Table
o Detaching the table
Pull the table away from the machine, as illustrated, for
"free-arm" sewing of cuffs and sleeves.
o Attaching the table
Push the extension table until it snaps into the machine.
0
Extension table
(_ Tab
(_ Pin
® Free-arm
(_) Hole
o Accessory box
Openthe cover of the accessory box toward you°
Sewing accessories are conveniently located in the box
Changing
Needle
(_) Needle clamp screw
Needle clamp
[]Turn
off the power switch°
Raise the needle to its highest position by turning the
handwheel counterclockwise,
toward you, and lowering
the presser foot° Loosen the needle clamp s'crewOby
turning it counterclockwise.
Remove the needle from the
needle clarnp(._).
[] Insert a new needle into the needle clamp(_)with
the
flat side to the rear.. When inserting the needle into the
needle clamp (_, push it up as far as it goes. Tighten
the needle clamp screw (_ firmly by turning it clockwise.
[]To
see if the needle is good, place the flat side of the
needle onto something flat (eg needle plate or glass)..
The gap between the needle and the flat surface should
be consistent+ Never use a bent or blunt needle
A damaged needle can cause permanent snags or runs
in knits, fine silks and silkJike fabrics.
To Remove and Attach the Foot Holder
(_) Thumb screw
(_) Foot holder
Presser bar
• To remove
Remove the thumb screw (_by turning it counterclockwise
with a screwdriver,
° To attach
Match the hole in the foot holder(_)with the threaded
hole in the presser bar (_)o Fit the thumb screwOinto
the hole<,Tighten the screw Oby turning it clockwise with
screwdriver_
F
f
®
Flat side
ILadopiano _
Needle
tMgplat
v ers
Aguja
AiguiIle
,S
[]
I
I
!
1
'N
\
J
10

Publicidad

Tabla de contenido
loading

Tabla de contenido