Threading The Machine; Drawing Up Bobbin Thread - Sears Kenmore 385.15108200 Manual De Instrucciones

Threading, the Machine
o Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise,
* Raise the presser foot tifter_
* Place a spool on the spool pin, with thread coming off as
shown,
[] Draw the end of thread around the upper thread guide_
[] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[] Firmly draw the thread up from right to left over the
take-up lever and down into the take-up lever eye
[] Slide the thread behind the needle bar thread guide on
the left.
[]Thread the needle from front to back or use a needle
threader.
o Drawing up bobbin thread
[] Raise the presser foot Hold the needle thread lightly
with your left hand and rotate the handwheel
counterclockwise, toward you, for one complete turn_
[_] Bring the bobbin thread up by pulling the needte thread
up,.
[] Pull both threads 4" to 6" (10_0 to I5,,0 cm) under and
behind the presser foot,
., J
.J
[]
T
m
[]
[]
24