Dreame A1 Manual Del Usuario página 30

3. Put A1 on a soft surface and turn it upside
down.
5. Remove the blade by aligning the hole of the
blade with the shaft.
7. Press the button under the blade disc and
align the hole of the receptacle with the shaft to
fasten the receptacles and the blades.
• Replacement of the cleaning brush
When the cleaning brush for the LiDAR sensor wears out, its bristles may fray or deteriorate, affecting its
cleaning performance. Please replace the cleaning brush regularly to keep a good cleaning result. It is
recommended to replace the cleaning brush every 12 months or sooner.
Note: Before replacing the cleaning brush, please make sure to unplug the charging station.
EN 30
4. Remove the receptacle by pressing the
button under the blade disc.
6. Remove 3 blades and receptacles.
8. Make sure the blades can rotate freely.