Kaco blueplanet 25.0 NX3 M3 Guía Rápida página 10

1.7 Creating equipotential bonding
NOTE
Depending on the local installation specifications, it may be necessary to earth the device with a second
ground connection. To this end, the threaded bolt on the underside of the device can be used.
The device has been installed on the mount.

1 Insert the earth conductor into a suitable M5 ring cable lug and crimp the contact.
2 Align the terminal lug with the grounding conductor on the screw.
»
3 Tighten it firmly into the housing [ P_2/
The housing is included in the equipotential bonding
Legend
1 M5 Ring cable lug
2 Earthing ground conductor
3 M5 screw (already pre-assembled)
1.8 Connecting the WLAN module
NOTE
Damage to the inverter due to electrostatic discharge
Components inside the inverter can be damaged beyond repair by electrostatic discharge.
› Ground yourself before touching any component.
› The COM3 connection is only suitable for the Wi-Fi stick included in the scope of delivery
or the 4G stick optionally available from KACO new energy.
The device has been installed on the mount.

1 Remove the cap on the COM3 connector
2 Insert the WiFi module into the existing connection and screw it into the connection using the nut on the WiFi module.
» The WIFI module is connected to the device.
3 Ensure the module is securely connected and the label on the module can be seen.
Fig. 18: Remove the cover
Page 10 KACO blueplanet 25.0 NX3 M2 KACO blueplanet 30.0 NX3 M2 KACO blueplanet 33.0 NX3 M2
2.5 Nm].
2.5 Nm
16–25mm²
Fig. 17: Connecting grounding
Fig. 19: Connect the wifi stick