Kaco blueplanet 25.0 NX3 M3 Guía Rápida página 6

1.4 Mounting the wall bracket
CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons under the device may be seriously
injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only suitable for masonry and concrete.
› Only install the device in an upright position.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation
mode due to insufficient ventilation and the resulting heat build-up.
› Observe minimum clearances and provide for sufficient heat dissipation.
› All objects on the device housing must be removed during operation.
› Ensure that no foreign bodies prevent heat dissipation following device installation.
Fig. 4: Drilling holes for wall mounting
Key
1 Drilling four holes [Ø 10mm with depth 70mm]
2 Insert screws and anchors
Cardboard packaging with mount and mounting kit removed from the packaging and opened.

1 Mark the mounting position on the wall surface according to the position of the mount plate by drawing four marks.
2 Mark the positions of the drill holes and drill four holes.
NOTE: The minimum clearances between two devices, or the device and the ceiling or floor have already been taken into
account in the diagram Fig. 3.1.
3 Fix the mount to the wall using suitable mounting fixtures from the mounting kit [ W-10].
NOTE: Make sure that the mount is oriented correctly. The arrow must be pointing upwards and be visible when the mount
»
is fastened to the wall.
Proceed with the installation of the device.
1.5 Installing the device
CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
› Always lift the device vertically using the grip recesses provided.
› Use a climbing aid for the chosen installation height.
› Wear protective gloves and safety shoes when lifting and lowering the device.
Page 6 KACO blueplanet 25.0 NX3 M2 KACO blueplanet 30.0 NX3 M2 KACO blueplanet 33.0 NX3 M2
Fig. 5: Mounting the wall bracket
3 Installing the wall holder