It is advisable to use the Caffi taly System descaling agent, designed to
comply with the technical characteristics of the machine, in full observance
of consumer safety. The descaling agent must be disposed of in compliance
with manufacturer instructions and/or with current regulations in force in the
country where the appliance is used.
CAREFULLY
Avoid contact with eyes, skin and machine surfaces.
Switch the machine off during descaling, and do not lift the lever.
A person must be present during the operation.
Do not use vinegar: it could damage your machine!
•
Switch the machine off by pressing the power on/off switch (Fig. 14).
•
Empty and rinse out the used capsule drawer and drip tray (Fig. 6).
•
Remove and empty the water tank (Fig. 5).
•
Mix the contents of a bottle of Caffi taly System descaling agent with approximately 750
cc. of water (a total of 1 litre) and pour into the tank.
•
Place a metal container (at least 500 ml) under the dispensing spout and the hot water
dispensing tube (Fig. 8).
•
Make sure that the lever is lowered (Fig. 3) and that there is no capsule inside the capsule
compartment.
•
Turn the control lever backwards (Fig. 22).
•
Press and hold button A while switching on the machine by pressing the power on/off
switch.
•
Button A lights up in BLUE, while button B and indicator light C blink alternately (YELLOW
and RED respectively).
•
Press button A to start the descaling cycle.
•
The machine dispenses the descaling solution at specifi c intervals (5 doses with a 4
minute pause between each one, for a total duration of about 25 minutes). During
this step, when the buttons must not be pressed, button B and indicator light C blink alter-
nately (YELLOW and RED respectively).
•
If the container fi lls up, empty it out.
•
When the fi rst step is complete, button A lights up in BLUE, while button B and indicator
light C blink alternately (YELLOW and RED respectively).
•
Carefully rinse out the water tank and refi ll it with fresh water (Fig. 4).
•
Empty and rinse the used capsule drawer, the drip tray and the container used and put
them back in position (Fig. 6).
•
Press button A to start the rinse cycle.
•
Rinse water (about 500 ml) will be run through the machine. Button B and indicator light
C blink alternately (YELLOW and RED respectively).
•
When the rinse cycle is complete, button B blinks YELLOW.
•
Set the lever back to its central position (Fig. 20).
•
Indicator light C blinks GREEN. When lit steadily, the machine is ready to use.
•
Carefully empty and rinse out the water tank and refi ll it with fresh, still water (Fig. 4).
•
Empty and rinse out the used capsule drawer and drip tray (Fig. 6).
24
English
Descaling
read the directions for use on the package of the descaling agent.