Monogram Advantium ZSB912 Advantium ZSB913 Manual Del Propietário página 27

TROUBLESHOOTING TIPS
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE
STATEMENT (U.S.A. ONLY)
This equipment generates and uses ISM frequency
energy and if not installed and used properly, that is in
strict accordance with the manufacturer's instructions,
may cause interference to radio and television reception.
It has been type tested and found to comply with limits for
ISM Equipment pursuant to part 18 of FCC Rules, which
are designed to part 18 of FCC Rules, which are designed
to provide residential installation.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following:
receiver.
the microwave oven and the receiver are on different
branch codes.
The manufacturer is not responsible for any radio of TV
interference caused by unauthorized modification to this
microwave oven. It is the responsibility of the user to
correct such interference.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: Microwave, ZSB912 and ZSB913
Modular Component: Wireless LAN Module
Modular Component FCC ID: COF-WMBNBM26A
Responsible Party:
FCC Compliance Statement: This device complies with
part 18 of the FCC Rules.
FCC Compliance Statement: This device complies with
part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found
49-7000077 Rev. 1
GE Appliances
Appliance Park,
Louisville, KY 40225
monogram.com
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
receiver.
different from that to which the receiver is connected.
technician for help.
To satisfy FCC RF exposure requirements, a separation
distance of 20 cm or more should be maintained between
the antenna of this device and persons during device
operation.
To ensure compliance, operations at closer than this
distance is not recommended.
Any changes or modifications to this unit
WARNING
not expressly approved by the party
responsible for compliance could void the user's authority
to operate the equipment.
27