Hisense FT3B213 Serie Manual De Operación página 26

First use and installation
03
1.Lever screw covers on both sides of the door, and then disassemble screws with
the cross screwdriver,
2.Fix four connecting boards E (each side of door needs two)with the special screws C
provided in the plastic bag. Four screws C are required on both the left and right sides of
the door body, making a total of eight screws.
04
90°
=
90°
1. Check the flatness level of the cabinet with
the spirit level.
2. Check the squareness of the cabinet with the
square.
3. The weight of the cabinet door is less than
13.5kg.
as shown in the instruction figure.
≤13.5KG
C C
E E
05
1.Use wrench A to loosen the nut and remove the
connecting plate from the door.
2.Slowly and carefully push the unit into the
installation compartment. Great care needs to
be taken to avoid scratching floor because of
the metal compressor supporting board.
2 2
1 1
24