Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION
Only use sanding sheets that match in size. Larger sanding sheets extending beyond the
sanding wheel presents a laceration hazard and may cause snagging or tearing of the sanding
sheets.
Note:
The grinding wheel is equipped with a Velcro fabric for quick attachment of the sanding sheet.
9.3.1
Attaching sanding sheets
1.
Press the sanding sheet (8) evenly onto the grinding wheel (5).
Ensure that the sanding sheet (8) lies flush and that the holes are congruent with the suction
holes of the grinding wheel (5).
9.3.2
Removing sanding sheets
1.
Take off the sanding sheet (8) from the grinding wheel (5).
9.3.3
Removing/replacing the grinding wheel (Fig. 7)
1.
If necessary, remove the sanding sheet (8) as described under Changing the sanding sheet
(Fig. 6).
2.
Loosen the four Phillips screws (12) with a Phillips screwdriver (not included in the scope of
delivery).
3.
Remove the grinding wheel (5) from the motor unit.
4.
Fit the grinding wheel (5) again in reverse order.
Ensure that the centring lugs in the motor unit match the mountings on the grinding wheel (5).
10 Working instructions
Note:
Negligent use of personal protective equipment (PPE)
Careless use or omission of personal protective equipment may result in serious injury.
WARNING
Do not use the product without the dust bag or external dust extraction unit in place.
Using a dust extraction unit can reduce hazards caused by dust.
Dust extraction is not possible when using sanding sheets without holes.
Ensure that the workplace is well ventilated.
Note:
Clean the grinding wheel before putting on a sanding sheet.
• Always guide the product against the workpiece when switched on. After machining, lift
the product from the workpiece and only then switch it off.
• Only work with flawless sanding sheets to obtain good sanding results.
www.scheppach.com
GB | 39
Publicidad
