Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
□
Ensure the power is turned on for the light (B).
□
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
A
3
Adjusting the motion sensor
detection zone
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light (B). The light will come on
indicating motion has been detected.
□
Stop, wait for the light to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
□
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
□
Note: Moving the motion sensor (C) "UP"
increases the distance of the detection
zone. Moving the motion sensor (C)
"DOWN" decreases the distance of the
detection zone.
There are built-in stops in the motion sensor (C). Do
not rotate the motion sensor (C) past these stops.
2
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
□
Set the "ON-TIME" switch to the "TEST"
position.
□
Set the "Brightness" switch to the "Default"
position.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
2
Brightness
Lo
Med
Hi
9
Please contact 1-866-308-3976 for further assistance.
On Time
1Min
20S
Eco
Wired: 5min
Test
Solar: OFF
Default
Battery: OFF
C
C
C
HOMEDEPOT.COM
Publicidad
