SYMBOLS
CARBON MONOXIDE (CO) SENSOR
In the event of a carbon monoxide hazard,
the LED on the CO sensor will flash red
and the generator will shut off. Leave the
area immediately and relocate to an open
outdoor area. Ventilate the area thoroughly
before occupying again. Ensure the generator is located in an open, outdoor area at least
20 feet away from all doors, windows, and occupied spaces. Always point exhaust away
from occupied structures. Never run the generator in enclosed areas (e.g. not in a house
or garage).
DO NOT tamper with, adjust, or modify the carbon monoxide (CO) sensor module on your
generator.
FUEL WARNING
No smoking when filling with gasoline.
Do not overfill. Full level is 1 in. below the
top of the fuel neck. Stop the engine for
five minutes before refueling to avoid the
heat from the muffler igniting fuel vapors.
ENGINE LUBRICANT WARNING
You must add lubricant before first op-
erating the generator. Always check the
lubricant level before each operation.
The lubricant level should always register
between the hatched areas on the dipstick. The unit is equipped with a sensor which will automatically shut off the engine
if the lubricant level falls below a safe limit.
GROUNDING WARNING
This generator does not include a ground rod or
copper wire. Call a qualified electrician for local
grounding requirements.
CLEARANCE WARNING
While operating and storing, keep at least 3
feet of clearance on all sides of this product,
including overhead. Allow a minimum of 30
minutes of "cool down" time before storage.
Heat created by muffler and exhaust gases
could be hot enough to cause serious burns and/or ignite combustible objects.
HOT SURFACE WARNING
Do not touch the muffler or aluminum cylinder of the engine. They
are very HOT and will cause severe burns. Don't put body parts
or any flammable or combustible materials in the direct path of
the exhaust.
Page 7 — English