Teka HLC840 Instalación/Mantenimiento página 35

When closing the oven door during cooking,
the sound of the air inside it can be heard. This
effect is normal due to the pressure exerted by
Accessories
Do not leave any containers or food on the oven
floor. Always use the trays and racks supplied
with the oven.
To prepare yoghurt, place the jars on the oven
floor.
To cook any other food, insert the tray or rack
into the runners inside the oven.
1. Between the two rails of the side supports or
on any of the extractable runners, if the oven
has them.
2. The rack and some of the trays have reten-
tion grooves to prevent them from acciden-
tally being removed. Place these grooves
towards the back of the oven, facing down-
wards. Figure 4.
3. The surface of the rack on which the con-
tainer will rest must be below the side rails.
This prevents the container from accidentally
sliding. Figure 5.
4. The trays have a tab at the front to facilitate
their removal. Place the tray with the tab
facing towards the outside of the oven. Fig-
ure 6.
ASSEMbLING THE TELESCOPIC RUN-
NERS.
Some oven models have a telescopic runner kit
accessory.
To assemble the telescopic runners on the
chrome-plated supports, proceed as follows:
the door when it is closed, guaranteeing the
sealing of the cavity.
Telescopic runners with folding clip
WARNING
The runners must be placed at height 2,
starting from below. Figure 12.
1. Remove the protective film.
2. Hook the large clips on the upper rail and
extend the runner until it hooks on the small
clips on the lower rail. Figure 12.
3. You will hear a "click" when the runner is cor-
rectly secured. Figure 13.
4. The notch to fix the tray/support must re-
main at the front part of the oven. Figure 13.
Telescopic runners with direct clip
WARNING
The single extraction runners must be
placed at heights 1, 2, 3 and 5 starting from
below. Figure 14.
The double extraction runners must be
placed at heights 1, 2 and 3 starting from
below. Figure 15.
In 45 cm ovens, the telescopic runners are
positioned at height 1. Figure 16.
1. Hook the clip on the top rail at the desired
level. Figure 17.
2. You will hear a "click" when the runner is cor-
rectly secured. Figure 18.
3. The notch to fix the tray/rack support must
remain at the front part of the oven. Fig-
ure 18.
English
Installation & Maintenance
35