Publicidad
Idiomas disponibles
Idiomas disponibles
Note: After spot cleaning, the robot will automatically
return to the starting point and enter Standby mode.
Pause
When the robot is running, press any button
to pause it, press the
button to resume
cleaning, and press the
button to send it
back to the dock.
Note: Placing a paused robot on the dock manually will
end the current cleanup.
Refilling the Water Tank or
Cleaning the Mop Cloth
To add water or clean the mop cloth, press
any button to stop the robot and remove the
mopping module. After adding water or
cleaning the mop cloth, reinstall the mopping
module and press the
button to continue.
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button
to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
Child Lock
Press and hold the
button to enable/
disable the child lock. You can also set it in
the app. Once enabled, the robot will not
react to button presses when it is stationary.
When the robot is cleaning or docking, press
any button to stop it.
Charging
After cleaning, the robot will automatically
return to the dock to charge. In pause mode,
press the
button to send the robot back
to the dock. The power indicator will breath
as the robot charges.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the
dock manually to recharge.
Error
If an error occurs, the power indicator will
flash red and a voice alert will sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
System Reset
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system. Press the Reset button, and the
robot will reset automatically.
Note: After resetting the system, scheduled cleaning,
WiFi, etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after a
09
system reset, switch it on. Press and hold the
button and at the same time, press the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot will
then be restored to factory settings.
Routine Maintenance
C
Main Brushes
C1
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush Bearings
C1-4—Main Brush Caps
C1-5—Main Brushes
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-7—
Remove the main brush and pull out
the main brush bearing.
C1-8—
Pull out the main brush caps.
C1-9—
After removing the tangled hair or
dirt at both ends of the main brushes,
reinstall them, press on the main brush
cover to lock it in place until hear a "click".
Make sure that the main brush cover
has been properly attached.
Notes:
• Main brushes should be wiped down with a wet cloth
and left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brushes.
Publicidad
