Angelcare AC201 Manual Del Propietário página 11

Setting Up Your Monitor
SENSOR PAD (See figs. 1 and 2)
• Connect the Sensor Pad cord to the Nursery Unit.
• Place the Sensor Pad in the middle of the crib under the mattress, as illustrated below. Make sure the printed side faces up. Do NOT
place any bedding between the mattress and the sensor pad.
• Secure the sensor pad cord to crib using a tie wrap. Run the cord on the floor to ensure it is out of the baby's reach.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or slat base, place a hard board between the
crib base and the Sensor Pad measuring at least 13" x 13" (33x33 cm) and 1/4 inch (6 mm) thick. Make sure the sensor pad's cord
passes underneath the mattress as shown below.
• The sensor pad works with all baby bed sizes and all mattresses, except memory foam mattresses. You will have to test your sensor
pad on p.16.
• Once you are done using the Sensor Pad, please remove it from the baby's crib and store it away.
• The Angelcare Sensor Pad feature is not designed for use with adults, children or infants older than 24 months.
Figure 1
PLACEMENT OF SENSOR PAD CORD
CORRECT
Sensor Pad
Figure 2
POSITION OF SENSOR PAD UNDER MATTRESS
CORRECT
Sensor Pad centered printed side up
Movement Sensitivity Control
IMPORTANT: Only use the AC adapters included with your monitor. Do not use these adapters with any
other equipment. Movement Sensitivity Control. The movement sensitivity control is on the back of the
Nursery Unit. The level has been preset to suit most conditions of movement detection (see fig.3). Do not
adjust this unless you receive false alarms. Refer to the Movement Sensitivity Adjustment section on for
Figure 3
more information. It is extremely important to follow our instructions for setting the sensitivity level. Now
plug the Sensor Pad cord into the jack on the back of the Nursery Unit marked "Sensor Pad." Turn the
Nursery Unit on using the switch on the left. The green Power Indicator will light up.
WARNING
STRANGULATION HAZARD - Children have STRANGLED in cords. Keep the adapter cords
and sensor pad cord out of the reach of children. Do not put the Nursery Unit inside a
crib or play yard. Because of the serious strangulation risk to infants and toddlers, par-
ents and caregivers should never place the nursery unit within 3 feet (1 meter) of a crib.
NEVER use extension cords with AC adapters. ONLY use the AC adapters provided.
IMPORTANT
Keep at
least 1m
(39 inches)
apart
(Top Down View of Crib)
INCORRECT
Sensor Pad off center
11
INCORRECT
Sensor Pad
INCORRECT
Sensor Pad printed side facing down