Care And Maintenance; Troubleshooting - Angelcare AC201 Manual Del Propietário

Care and Maintenance

Disconnect all units and remove all batteries before cleaning. Clean the exterior surface of the units with a
soft dry or slightly damp cloth. Do not spray with cleaning products or solvents.
Do not submerge in water or any other liquid.
During long periods of non-use, remove all batteries from their compartments and unplug the AC adapters.

Troubleshooting

Problem
False alarms
Possible Cause
Baby was removed from crib and the Nursery
Unit was not switched off.
The printed side of the Sensor Pad is not
facing up.
The Sensor Pad is not detecting your baby's
movements because the sensitivity level is
too low.
Sensor Pad is not in full contact with the
crib mattress or is not resting on a flat, firm
surface.
Baby has moved far away from the Sensor
Pad.
17
Solution
Turn the Nursery Unit off.
Make sure the printed side is facing up.
The sensitivity level may need to be
increased.
Refer to the Movement Sensitivity
Adjustment section.
Make sure there is no bedding between
mattress and the Sensor Pad. The Sensor
Pad must rest on a completely flat and
firm surface. If the crib has a spring or slat
base, place a hard board between the crib
base and the Sensor Pad measuring at
least 13" x 13" (33x33 cm) and 1/4 inch
(6 mm) thick.
Make sure that the sensor pad is installed
as shown. The sensitivity level may also
need to be increased. Refer to the
Movement Sensitivity Adjustment section.