EXTRACTION OF THE INSERT
To extract the insert, proceed as follows:
CAUTION:
BEFORE PROCEEDING, MAKE SURE THAT THE IN-
SERT IS FIXED TO THE BASE
• Open the door and lift the slide lock (F – Fig. 5).
• Attach the handle provided to the two pins fi xed to the lower
grille (G - fi g. 6) and pull the insert towards you as far as it will
go (fi g. 7).
• Using the handle (G – Fig. 6), pull the insert towards you
until it stops (Fig. 7).
• Each time the insert is removed, a security system cuts
off the power supply. Should the insert be removed invo-
luntarily during ignition, operation or while switching off
(including while blocked), the "Power failure" block phase
will be launched when the insert is reinserted. Wait for the
block phase to end before reactivating the insert.
INSTALLATION
fi g. 5
fi g. 6
fi g. 7
- 42
-
F
G