Concept RK3350 Manual Del Usuario página 19

EN
PRODUCT DESCRIPTION
1 Handle for opening the lid
2 Lid
3 Touch control buttons
4 Handle
5 Appliance body
6 Base
7 Water level indicator
2
5
6
NOTICE:
Before first use, we recommend boiling the maximum volume of water at least 3 times and pour it out. Afterwards, the
kettle is ready for use.
The kettle may only be used with the supplied base.
36
1
3
4
OPERATING INSTRUCTIONS
1. Remove the kettle from the base, open the lid and fill it with cold water (the water level must be within the MIN-
MAX watermarks inside of the kettle). If you fill the kettle with too little water, it could be switched off before the
water starts boiling.
2. Place the kettle on the base. The electrical contacts will connect automatically. Thanks to the central connector
design, the kettle can turn around 360° and can be placed on the base from any side.
3. By pressing the START/CANCEL button, the kettle automatically boils water to 100 °C.
4. If you want to select temperature in range 70/80/90/100 °C, place the boiler on the base and select the temperature
using buttons +/- after lighting up all icons. Press On/Off button to confirm the selection and the kettle starts
heating the water.
5. After the boiling point is reached, the kettle automatically switches off.
6. Remove the kettle from the base and use the water.
7. If you need to reheat the water that has just been boiled, wait approximately 30 second before switching on the
kettle again.
Note:
• The heating process can be interrupted by pressing the START/CANCEL button.
• A few drops of water appearing on the base of the kettle after use is not a sign of a defect. It is a small amount of
condensed water, which deactivates the kettle thermostat.
• The kettle has a "Keep warm" function (i.e. maintaining warm water temperature). Place the kettle on the base and
set the required temperature. Then press and hold On/Off button for 3 seconds. The bottle will heat up the water
until set temperature has been achieved (sound signal will be heard). This temperature will be maintained for 30
minutes, then the kettle will be switched off automatically.
• The kettle has protection against switching on without water.
CLEANING AND MAINTENANCE
Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet! Make sure the appliance has
cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse it in water!
Descaling
During normal use, deposition of impurities from water occurs. Use commercially available descaling agents to clean
them (follow the manufacturer's instructions).
Note: Remove the deposits regularly, approximately once a week, depending on the water hardness and frequency of
use. The deposits significantly reduce the heating capacity and the lifespan of the appliance.
EN
37