ADURO H1 Manual De Usuario página 67

Pakninger
All maintenance and cleaning of the Aduro H1 should be carried out when the
Med tiden bliver pakningerne slidte og bør derfor efterses. Er de utætte, bør de skiftes.
stove is cold and power disconnected.
6.1 Daily maintenance – when using pellets
When you add pellets, you should brush the burning cave free from of ashes and cinders. Open the door to
the combustion chamber and lift the front of the burning cave (the black cast iron cone with the Aduro logo).
Brush the ashes and the cinders through the grate to the ash pan. Avoid brushing ashes and cinders down
into the pellet auger. Put back the front of the burning cave.
Empty the ashpan when needed.
Burning cave
We recommend two types of maintenance during the week: a short cleaning while the stove is lit (cannot last
more than 3 minutes because of the sensor in the door) and a thorough cleaning where the stove is turned
off and cold. We recommend that you conduct the short cleaning 2 times a day and the thorough cleaning
every 4 days.
During the short cleaning, the stove must be cleaned under the burning cave. We recommend that you use
gloves. By using a tong or a similar tool, you can move the burning cave to the side and clean out ash and
cinders. Put the burning cave back in place. During the thorough cleaning, the fireproof tiles must be
removed and the auger and the combustion chamber must be vacuumed thoroughly.
6.2 Regularly maintenance – when needed
Ashes
Empty the ashpan before it gets completely full. Always leave a layer of ashes in the stove because it
insulates and makes it easier to light a fire.
Remove the burning cave and clean the top auger for ashes with a vacuum cleaner. This is done easiest by
making a "paper ring" of paper roll, which is laid around the opening of the auger. Then press the vacuum
cleaner muzzle down towards the "paper ring" so it fits tightly. After this, the ashes can be vacuumed up.
Glass
Wet wood, insufficient chimney draft, and wrong use of the hybrid stove can leave soot stains on the glass.
They can easily be removed using a damp cloth that you dip in cold ash and rub on the sooty glass. Special
cleaning agents are also available to remove soot from glass, e.g. the Aduro Easy Clean pad. The pad
neither scratch nor damage the glass and is for multiple usage. Water or other cleaning agents are not
necessary.
It is common maintenance to tighten the glass fittings shortly after the stove has been installed as well as to
check if the gaskets are properly placed.
6. Maintenance of the stove
67