Operation; Start-Up And Normal Operation - MGE Pulsar M 2200 RT 2U Manual De Instalación Y De Usuario

E E N N G G L L I I S S H H
3.1

Start-Up and Normal Operation

i
For the initial start-up, AC power must be present to detect any wiring errors. After inital start-up, the UPS can start even
if AC power is not present.
UPS personalization
i
If UPS personalization is desired, it is advised to enter the personalization mode at this time.
This mode may be entered using the buttons on the control panel or the Personal Solution-Pac Software (Windows)
included on the Solution-Pac CD-ROM provided by MGE Office Protection Systems.
86-86710-00 A01
Press button (27) for approximately 1 second.
◗ The buzzer beeps once and all the LEDs go
ON simultaneously.
◗ The buzzer then beeps twice during the self-
test, then button (27) remains ON, indicating
power to the output receptacles.
The connected devices are protected by the
UPS.
◗ LED (20) is ON.
If LED (22) is ON, a fault has occurred (see
the "Troubleshooting" section).
◗ During normal operation, the scroll button
(25) may be used to read UPS measure-
ments (voltage on normal and bypass AC
inputs, operating mode, battery capacity and
UPS serial number).

Operation

Operation
3 — 1