Activating The Remote Flash Mode As Controller - Metz MECABLITZ 58 AF-1 digital Manual De Instrucciones

Setting the parameters
P CH1
TTL
Master
AZoom 35
EV 0
• Press the
Para Sel
parameter appears on the display. Here it is possible
to make settings for...
P CH1
TTL
EV+1
Master
AZoom 35
EV+1
Mode Para – +
CH3
CH3
AZoom 35
Para – +
- and MZoom: Reflector position; 24mm (18mm with
wide angle attachment) up to 105mm are possible.
• Use the (+) and (-) buttons to make the desired settings.
• Store the setting with the button. If the
tings will be saved automatically after approximately 5 seconds.
138
Para
button repeatedly until the desired
- EV: Flash exposure correction; -3 EV to
+3 EV in increments of one third are pos-
sible
- Channel: Remote channel; channels 1 to 4
are possible
button is not pressed, the set-

19.2 Activating the remote flash mode as Controller

• Press the Sel button repeatedly until "Select"
appears on the display.
• Use the and buttons to select "Remote"
from the menu. The selected menu option is indicated
by a dark bar.
• Press the Set button to confirm the selection of
"Remote".
• Use the and buttons to select "Remote
Master/Control". The setting is effective immediately.
• Press repeatedly to return the display to normal.
If the button is not pressed, the display will
switch back to normal automatically after approxi-
mately 5 seconds.
• Press the Para button repeatedly until the
button is also displayed.
• Press the Mode button repeated until "Control"
appears on display.
Setting the parameters
• Press the Para button repeatedly until the desired
parameter appears on the display. Here it is possible
to make settings for...
– Channel: Remote channel; channels 1 to 4 are
possible
– and MZoom: Reflector position; 24mm (12mm with wide angle attachment)
up to 105mm are possible.
+
–
• Use the and buttons to make the desired settings.
• Store the setting with the button. If the
tings will be saved automatically after approximately 5 seconds.
BEEP
Select
Remote
FB
Set
Remote
Master/Controller
Set
Mode
CH1
P
TTL
Controller
AZoom 35
F32
Para Sel
button is not pressed, the set-