Vorel 80970 Manual página 15

Solvents, which are used to clean the tool holder and the body, can cause seals softening. Thoroughly clean the tool before
starting your work.
In case of finding any irregularities in the tool operation, the tool you should be immediately disconnect from the pneumatic
system.
All the elements of the pneumatic system must be protected against contamination. Contamination, which enters the pneumatic
system, can damage the tool and other air system components.
Maintenance the tool before each use
Disconnect the tool from the pneumatic system.
Before each use, let a small amount of liquid preservative (e.g.. WD-40) through the air intake.
Connect the tool to pneumatic system and run for about 30 seconds. This will distribute the liquid preservative inside the tool
interior and will clean it.
Again, disconnect the tool from the pneumatic system.
Let small amount of oil SAE 10 to the inside of the tool, through the air inlet and the holes intended for this purpose. It is recom-
mended to use oil SAE 10 intended for maintenance of pneumatic tools. Connect the tool and run it for a short time.
Attention! Maintenance liquid may not be used as an appropriate lubricating oil.
Remove excess of oil, that spill out through the holes. Left oil may damage the tool seals.
Other maintenance operations
Before each use, you should check whether the tool shows any traces of damages. Drivers, tool holders and the spindles must
be kept clean.
Every 6 months or after 100 hours of operation, you must pass the tool for inspection by the qualified personnel in the repair
shop. If the tool was used without the application of recommended air supply system, you should increase the frequency of the
tool inspections.
Troubleshooting
You should stop using the tool immediately after the disguardy of any fault. Work with a defective tool can cause injury. Any repair
or replacement of tool components must be carried out by qualified personnel in authorized repair facility.
Failure Possible solution
Let a small amount of the preserative liquid through the air inlet. Run the tool for a few seconds. The blades may stick to the rotor. Run the
The tool has too slow
tool for about 30 seconds. Lubricate the tool with small amount of oil. Attention! The excess of oil can cause a decrease in power of tool.
rotations or it does not start
In this case, you should clean the drive.
The tool starts and then The compressor does not provide proper air supply. The tool starts by the air collected in the tank of compressor. As the tank is emptying,
slows down the compressor has not kept pace with the refilling of air shortages. Connect the device to a more efficient compressor.
Make sure, that your hoses have an internal diameter, at least such as it is specified in the table in paragraph 3. Check the set point of
Insufficient power pressure, whether it is set to the maximum value. Make sure, that the tool is properly cleaned and lubricated. In the absence of results,
you should pass the tool for repair.
Transport of the product
The product should be transported in individual packaging.
Storage of the product
Before starting the storage, you should maintain the product as described in the instruction. Keep the product in the included
individual packaging. Store the product in a dry and shaded places. The storage location should be protected against unauthorized
access, in particular against access of children.
Handling of waste tools
Worn tools are secondary raw materials, it is forbidden to dispose of them together with household waste. because they contain
substances harmful to human health and the environment! Please actively support the cost-effective management of natural
resources and environmental protection by passing the used equipment to the point of storage for worn out devices. To reduce the
amount of disposed waste it is necessary to re-use them, recycle or recover in another form.
O R I G I N A L
GB
I N S T R U C T I O N S
15