Optika Italy IM Serie Manual De Instrucciones página 11

3. Plug the power cord into the socket of the power supply. (Fig.
13)
4. Plug the power cord into the mains socket.
• Check for a safe connection.
• Please use the provided power cord.
• If lost or damaged, please refer to qualified service.
• Connect the power cord to a grounded power supply
only.
8.7 Installing mechanical stage or stage extension
• Stage extension and mechanical stage are optional ac-
cessories.
• Stage extension can be installed on either side of the stage
to enlarge the working surface.
• Mechanical stage can only be installed on the right side.
1. Installing the units: screw the bolts in the fixing holes of the
stage, then mount the unit from below the stage. (Fig. 14)
• NOTE: The stage has a series of holes in the underside.
To install the mechanical stage it is necessary, starting
counting from the front of the microscope, to use the
third and fifth holes. By using a different set of holes, the
mechanical stage will not be installed correctly.
8.8 Installing polarizer and analyzer
1. Insert the polarizer "S-PO", with the "S-PO" inscription facing
the front of the microscope, into the slot ① placed on the left
side of the LED housing support. (Fig. 15)
2. Insert the analyzer "S-ANR", with the "S-ANR" inscription fac-
ing up, in the slot ② placed on the left side of the microscope
body. (Fig. 16)
Page 11
F ig. 13 F ig. 13
F ig. 14 F ig. 14
①
F ig. 15 F ig. 15
②
F ig. 16 F ig. 16