Mitsubishi Electric MSZ-FH09NA Manual De Instrucciones página 5

Changing temperature units (°F--PC)
Unit is preset with °F.
]I
Press
RESET while
the temperature but-
tons are pressed.
. Press RESET gently using a thin instrument.
To change temperature unit from °C to °F, press RESET.
Setting the installation position
Be sure to set the remote controller in accordance with the installed position of
the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the teft
Center: Distance to objects (wall, cabinet, etc.) is more than 19-11/16 in. (50
cm) to the left and right
Right: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
(Left) (Center) (Right)
WIDE VANE
...........Hold down _ on the remote controller for 2 sec-
onds to enter the position setting mode,
............ WIDEVANE
_ Select the target installation position by pressing _.
WIDE VANE
(Each press of the _ displays the positions in
order:)
(Center) (Right) (Left)
_ Press _ to complete the position setting.
Note:
The installation position can be set only when all the following conditions are met:
. The remote controller is powered off.
. Weekly timer is not set.
. Weekly timer is not being edited.
II
En-4