• OPERATING INSTRUCTIONS
•
I
In the i-see control
mode, the room temperature
is controlled
based on the
sensible temperature.
_
Press
O
during COOL, DRY, HEAT and AUTO mode
SENSOR
to activate the i-see control mode.
, Press gently using a thin instrument.
, _
lights. (Operation
display section)
, The default setting is "active".
SENSOR
.......... Press
O
again to activate ABSENCE DETECTION.
, _
lights. (Operation
display section)
_
Press SE_OR again to release the i-see control mode.
Note;
Any person at the following places cannot be detected:
•
Along the wall on which the air conditioner
is installed
•
Directly under the air conditioner
•
Where any obstacle,
such as furniture,
is between
the person and the air
conditioner
A person may not be detected
in the following
situations:
Room temperature
is high.
A person wears heavy clothes and his/her skin is not exposed.
A heating element of which temperature
changes significantly
is present.
Some heat sources, such as a small child or pet, may not be sensed.
A heat source and the air conditioner
are more than 20 ft (6 m) apart.
A heat source does not move for a long time.
This function
automatically
changes
the operation to energy-saving
operation
when nobody is in the room.
this function, press Sg_OR u ntil _1_ appears
on the operation display of the remote controller.
SENSOR
...... Press
_-) again to release ABSENCE DETECTION.
The INDIRECT/DIRECT
mode offers finely-tuned
operation
by locating where
an occupant
is in the room.
INDIRECT/DIRECT
.......... Press
during COOL, DRY, HEAT or AUTO
mode to activate the INDIRECT/DIRECT
mode. This
mode is only available when the i-see control mode is
effective.
INDIRECTIDIRECT
.........
__i_t-_
Each press of {_i_¢,] changes INDIRECT/DIRECT
in
the following order:
g:::::::3
g::::::3
g:::::::3
,_
_
n
_
._
._
&
&
DIRECT)
(DIRECT)
(OFF)
C::ZZ3
_'_ (INDIRECT): An occupant will be tess exposed to
direct airflow.
& (DIRECT)
" Mainly the vicinity of an occupant wilt
be air-conditioned.
• Horizontal
and vertical airflow directions
will be automatically
select-
ed.
• When more than a couple of people are in a room, the INDIRECT/DI-
RECT mode may work tess effectively.
• If you still feel uncomfortable
with the air direction
determined
by the
INDIRECT
mode, adjust the air direction
manually.
_
anceling the i-see control mode automatically cancels
the INDIRECT/DIRECT
mode.
• The INDIRECT/DIRECT
mode is also cancelled
when the VANE or
WIDE VANE buttons is pressed.
Note;
Do not touch the i-see sensor. This may cause malfunction
of the i-see sen-
sor.
,
The intermittent
operating sound is a normal sound produced when the i-see
sensor is moving from side to side.
En-5