Publicidad
Idiomas disponibles
Idiomas disponibles
The position as a fl oor-mounted appli-
ance is also ideally suited to allowing
the device to cool down after use.
Use of adapter nozzles
Before exchanging adapter nozzles,
the adapter nozzle (5/6/7/8) and
blow-off pipe (4) must be suffi ciently
cooled down to avoid burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.
Restrictor
Place the restrictor (8) on the blow-off pipe (4).
Use the restrictor (8) to obtain selective heat.
When using the restrictor (8), pay
particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.
Surface nozzle
Place the surface nozzle (6) on the blow-off
pipe (4).
Use the surface nozzle (6) to obtain heat
over a large surface.
When using the surface nozzle (6),
pay particular attention to the heat
development in adjacent locations
of the cutting point. So that in cases
of doubt, no adjacent component is
overheated.
Spatula nozzle
Place the spatula nozzle (7) on the blow-off
pipe (4).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers must be removed with a spatula.
The spatula nozzle (7) itself is not suitable
for removing paint.
Grill lighter nozzle
Place the grill lighter nozzle (5) on the
blow-off pipe (4).
Change the device with the step switch
3) to level "II". Place the grill lighter
(
nozzle (5) below the charcoal. Make sure
that the openings of the grill lighter nozzle
(5) are not covered by charcoal as this cre-
ates heat accumulation in the unit, which is
a potential fi re hazard In just a few minutes
the charcoal is ignited.
Never use other methods for ignit-
ing charcoal at the same time while
using the grill lighter nozzle (5).
Use the grill lighter nozzle (5) only
for the few minutes necessary to
ignite the charcoal.
Never use the grill lighter nozzle (5)
for any other application.
Cleaning/maintenance/
storage
Ask our service centre to carry out
any work that is not described in
these instructions. Do not try to re-
pair the device by yourself, unless
you have professional training. Use
only original parts.
GB
MT
17
Publicidad
