Dacor DRF36750 Serie Manual Del Usuario página 22

Operations
06 Filter Reset (3 sec)
Filter Reset
07 Deodorizer Reset (3 sec)
Deodorizer
Reset
08 Door Alarm / °C  °F (3 sec)
Door Alarm
°C  °F
09 Override (3 sec)
Override
22 English
FDR_Dacor_BRF8000M_DA68-03574B-05_EN.indd 22
After about 6 months of using the original water filter (which typically
amounts to about 300 gallons (1136 liters) of water), the Filter
indicator blinks red to remind you that the filter needs to be replaced.
When this happens, replace the filter, and then press and hold Filter
Reset for 3 seconds. This resets the filter lifecycle detector and turns
off the Filter indicator.
NOTE
• Some areas have relatively large amounts of lime in their water.
This may reduce the lifecycle of the filter. In these areas, you will
have to replace the water filter more often than specified above.
• If water is not dispensing properly, the water filter is most likely
clogged. Even if the Filter indicator is not blinking, replace the
water filter.
After about 18 months of using the original deodorizer filter, the Filter
indicator blinks red to remind you that the filter needs to be replaced.
If this happens, replace the filter, and press and hold Deodorizer Reset
for 3 seconds. The filter lifecycle will be reset and the Filter indicator
turns off.
You can enable or disable the door alarm by pressing Door Alarm.
When Door Alarm is enabled and a door is left open for more than 2
minutes, the alarm will sound and the alarm indicator will blink. The
Door Alarm function is enabled by factory default.
You can use the Door Alarm button to switch the temperature scale
between Celsius and Fahrenheit.
To switch the temperature scale, press and hold Door Alarm for
3 seconds.
The Override function activates/deactivates Smart Grid.
Press Override for 3 seconds to set/clear the Override function.
2020-12-11 4:45:58