Publicidad
Vanity Combo Installation Instructions
Tools and Materials Recommended for Installation:
A team of two persons will ease the assembly and installation process
• Variable Speed Drill & Drill Bits
• Screwdrivers (Phillips & Flat Head)
• Level, Tape Measure, Stud Finder
• Clear Silicone Caulk/Sealant*
• Faucet and Drain Connections
• Adjustable Wrench
• Hardware to Secure to Wall (Suggest 3/16" x 2½" Lag Bolt)
* Do not use plumber's putty
Step 1: Locate Wall Studs
• Determine the exact area on the wall where the cabinet is to be placed.
• Locate at least one (1) wall stud within the desired area. If a wall stud is not
present, we recommend toggle bolts or an appropriate wall anchor.
Step 2: Install Vanity
• Use the adjustable glides to level the vanity.
• Drill ¼" diameter hole in vanity back wall/back rail. Drill ¹⁄8" diameter pilot hole into center of stud.
Note: As you drill holes into wall, use caution to avoid damaging water line/drainage system or
electrical wires.
• Fasten the vanity to the wall studs through inside of cabinet.
Step 3: Trial Fit Vanity Top
• Trial fit the vanity top onto the vanity to ensure level fit, then remove vanity top.
Step 4: Install the Faucet & Drain
• Install the faucet, drain and supply lines per manufacturer's instructions (if the faucet requires
plumber's putty use clear silicone caulk/sealant* instead).
• Place ring of caulk/sealant around drain flange.
• Tighten securely. Avoid over-tightening as it can result in damage to the finish.
• Wipe off excess sealant.
* Plumber's putty contains oils that can cause damage to the finish.
Step 5: Install the Vanity Top
• Place a bead of clear silicone caulk/ sealant on the backside, top edge of the backsplash and on
all top corner edges of the vanity.
• Carefully place the vanity top on the vanity and press firmly into place.
• Wipe off excess sealant. Let sealant set until dry.
Note: Bathroom walls may be uneven and slight gaps may occur. Fill gaps with sealant.
Publicidad
