BH FITNESS G6515 Manual Del Usuario página 11

IMPORTANT: This is not a medical
appliance and therefore the heart rate
shown is merely
purposes.
NOTE: Adjusting the volume to high
levels may cause interference with the
pulse signal. If this happens, decrease
the volume.
LUBRICATION
FUNCTION.-
This machine has a built-in lubrication
warning. After running a distance of
E01 Possible cable fault
E02 Motor failure
E03 No speed sensor signal
E04 Calibration error
E05 Possible motor overload
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
for guideline
REMIND
ERROR CODES
300 km, the monitor will display OIL.
This means that your machine needs
lubrication.
indicated in the LUBRICATION section
and then press any key for 6 seconds.
This will clear the warning and reset
the distance until the next lubrication.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
Connect the wire between top controller and
console.
Check the motor wires. Replace the motor if
necessary.
Check the position or replace the speed
sensor.
Change the control board.
a.- Lubricate the belt.
b.- Check that the motor is not burned.
c.- Check that the control board is not burned.
11
Lubricate the belt as