cecotec CECOFRY RAIN Manual De Instrucciones página 27

ENGLISH
Note:
- The data shown in the table are measured for a 20-minute cycle.
- The data obtained have been calculated with Virgin Olive Oil and at an ambient temperature
of 25ºC. If you get different results it may be due to the use of different types of oils and
their different densities.
Do not use oils and fats that are solid at room temperature. Note that very low temperatures
can solidify the oil. Clean the tank and internal oil tubes after each use.
If you change the cooking time to more than 20 minutes, the device will spray every 2 minutes
for all levels with the amount of oil per spray corresponding to each level.
If you decrease the program time to 15 minutes, the air fryer will perform the first full range and
3 more minutes of the next full range
Programme DIY: MANUAL.
The DIY or manual program is a special program that allows you to spray oil whenever you
want. To do this, select this program and oil level 0. Oil levels can be used with this program
and you can spray manually.
4. CLEANING AND MAINTENANCE
Cleaning
- Clean the appliance after every use.
The protective grille, the basket and the basket grille have a non-stick coating. Do not use
-
metal utensils or abrasive products to clean them, as this may damage their non-stick
surface.
1. Unplug the appliance and allow it to cool down before cleaning.
Tip:
Remove the basket to let the appliance cool down more quickly.
2. Clean the inside and outside of the appliance with a damp cloth.
Tips:
- We recommend the use of liquid degreaser for food use to remove any remaining dirt.
- If the basket and grille are very dirty, soak them in hot water and cleaning solution for 10
minutes.
3. Clean the inside of the appliance with hot water and a non-abrasive sponge, taking care
not to damage the resistance.
4. Clean the spray nozzle with hot water and a non-abrasive sponge.
52
CECOFRY RAIN
5. Remove the protection grille and clean the grease with hot water, detergent and a
non-abrasive sponge.
6. To clean the tank and internal oil tubes, you can enter the DIY mode and at oil level 0
you can press the DIY button until the tank and internal tubes are empty, the device will
indicate that there is no more oil left by means of the "Add Oil" notice.
Storage
The power cable can be stored inside the appliance.
1.
2. Make sure all components are clean and dry.
3. Be sure to clean the sprayer and the removable protective grille.
5. TROUBLESHOOTING
Problem Possible causes
Temperature sensor
E1
not working
Temperature sensor
E2
not working
The air fryer does not The appliance is not
work plugged in.
The food is too big.
The temperature used
Cooked foods are raw.
is too low.
The preparation time
is too short.
Some types of food
The ingredients are
need to be shaken
cooked unevenly in the
during the cooking
air fryer.
process.
Increase temperature
The ingredients are
not crunchy.
Increase the oil level
ENGLISH
Possible solutions
Contact the official Cecotec Technical
Support Service.
Contact the official Cecotec Technical
Support Service.
Insert the power cord into an earthed wall
socket.
Put smaller batches of food in the basket.
Smaller batches are cooked more evenly.
Select a higher temperature (see the
"Operation" section).
Select a longer time (see the "Operation"
section).
Ingredients that lie on top of or across each
other (e.g. fries) need to be shaken halfway
through the preparation time. See section
"Operation".
Increase the cooking temperature to
generate greater dehydration in the
superficial layer of the same and obtain
more crunch.
Turn up the oil level for crispier results.
53
CECOFRY RAIN