AEG BBB8002QB Manual De Instrucciones página 86

12.1 What to do if...
Problem description
You cannot activate or operate the
appliance.
The appliance does not heat up.
The lamp is turned off.
Trouble with wireless network sig‐
nal.
New router installed or router con‐
figuration changed.
The wireless network signal is
weak.
The wireless signal is disrupted by
microwave oven placed near the
appliance.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
Code and description
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect with the
control panel.
F131 - the temperature of magnetron sensor is too
1)
high.
F602, F603 - Wi-Fi is not available.
1)
When the following error message continues to appear on the display, it means a faulty subsystem may have
been disabled. In such a case contact your dealer or an Authorized Service Centre. If one of these errors occurs,
the rest of the appliance functions will continue to work as usual.
86 ENGLISH
Cause and remedy
The appliance is not connected to an electrical supply or it is connected in‐
correctly.
The clock is not set.
To set the clock refer to "Clock functions" chapter.
The door is not closed correctly.
The fuse is blown.
Make sure the fuse is the cause of the problem. If the problem recurs, con‐
tact a qualified electrician.
Child Lock is activated.
The lamp is burnt out. Replace the lamp.
For details refer to "Care and Cleaning" chapter.
Check if your mobile device is connected to the wireless network. Check
your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer to "Before first use"
chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using microwave oven and the Remote operation of the appliance at
the same time. Microwaves disrupt WiFi signal.
Remedy
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
Turn the appliance off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the appliance off and on.
Turn the appliance off and wait until it cools down. Turn
the appliance on again.
1) Turn the appliance off and on.