Publicidad
Idiomas disponibles
Idiomas disponibles
Press flares firmly onto the vehicle and install and
fully tighten three screws (SW1-0050) into the clips
installed in step 18.
Edge Trim Tool Procedures:
Using supplied Edge Trim Tool (ET1-0002), seat
edge trim against vehicle by hooking curved end
under edge trim at one end of flare. Next, slide
around outer edge of flare to the other end.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-234-8920 (USA AND CANADA) • FAX 800-438-3788
20
Completed rear flare installation.
22
Using flat end of supplied Edge Trim Tool (ET1-0002),
seat edge trim against flare by inserting straight end
between edge trim and flare at one end. Next, slide
around entire edge to the other end.
21
23
Publicidad
