qLabs
ElectroMeter Plus, or
®
2) Insert a fresh test strip if you are ready to perform a test. The
qLabs
ElectroMeter Plus will then prompt you to confirm the test
®
type.
Turning the qLabs
to:
• Perform a test, or
• Check the version of the software and the manufacturer information
by pressing "VER" button, or
• Enter Setup mode by pressing "SET" button to change the
ElectroMeter Plus setting, or
• Enter Memo mode by pressing "MEM" button to review previous
results.
Turning the qLabs
• Perform a test.
See the appropriate sections of this User's Manual for
complete information for all of these options.
7.3 Powering the qLabs
OFF
SET
VER
SHUT DOWN
OK
BACK
ElectroMeter Plus ON in CHOICE 1, allows the user
®
V2.7.0.12
MICROPOINT
033200F0200009
ElectroMeter Plus ON in CHOICE 2, allows the user to:
®
ElectroMeter Plus Off
®
In the interface where the monitor prompts
you to insert a test strip, press the functional
"OFF" button to enter the shut down mode.
MEM
In shut down mode, the user can:
• Press the functional "OK" button to
• Press functional "BACK" button to
S/N
turn off and enter standby mode, or
return to the previous interface.
11
EN