Munchkin Push to Close Gate Manual Del Usuario página 5

How To Install
2. Size to your opening by sliding the hinge panel and catch panel outward towards the
wall. For ease of gate installment later, please keep between a 1.5" and 2"
(38mm-50mm) gap from the gate panel to the wall.
1.5" - 2.0"
(38mm-50mm)
of gap
3. Secure the hinge panel and catch panel together
using the upper and lower clamps. If the bars are
not lined up, shorten the gate width by sliding
panels inwards away from walls to allow room for
the clamps.
Use the small screws to attach the top and
bottom halves of each clamp together.
Small screw
8
1.5" - 2.0"
(38mm-50mm)
of gap
Upper clamp
Lower clamp
STEP 3: INSTALL LOWER HINGE (WALL BRACKET)
TOOLS NEEDED:
• Drill
• Phillips screwdriver
• Adhesive tape
• Hex key
• Pencil
• Wrench
1. Cut template along the dotted line to separate template "A" and "B".
2. Decide which side of your opening will be the hinge side
(i.e. the side that does NOT open). Next, place template
"A" against the wall using tape. Template should be flush
to the floor/step.
3. Mark the screw holes in the
cut-out piece with a pencil to create
indentation, then remove the cut-out
piece on bottom of template "A".
4. Determine whether there is a stud
behind the drywall where you will install the lower hinge wall bracket.
Proceed to either 5a or 5b.
PLEASE NOTE: Leave template "A" in place to help align the upper hinge bracket later.
How To Install
Template A
(Hinge side)
9