Munchkin Push to Close Gate Manual Del Usuario página 8

How To Install
3. Place again the upper hinge bracket against the
pencil lines on the wall and mark the screw
holes with a pencil to create indentation.
Then, remove template "A" from the wall.
4. Determine whether there is a stud behind the
drywall where you will install the upper hinge
bracket. Proceed to either 5a or 5b.
5a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at the
center mark. Insert a drywall anchor.
Use a screwdriver or drill to insert the screw through
the upper hinge wall bracket into the drywall anchor.
Medium Drywall
screw anchor
5b. For Drywall with Stud:
Drill a 5/64"(2mm) pilot hole into the stud
(no anchor needed).
Use a screwdriver or drill to insert the screw through
the upper hinge wall bracket into the stud.
Medium
screw
14
STEP 7: INSTALL UPPER CATCH (WALL BRACKET)
1. Place the gate back into position,
5a. Drywall
2. Place the upper catch bracket against the wall. If necessary, loosen the nut and extend
7/32"
(5.5 mm)
5a. Plasterboard
7/32"
(5.5 mm)
5b. Stud
5/64"
(2.0 mm)
hinge side first. Drop both the upper
and lower hinge pins into their
respective brackets at the
same time.
the adjustment rod on the upper catch side until it is seated in the bracket. (The rod
should press against the bracket's center button.) Then, mark the screw holes with a
pencil to create indentation.
How To Install
15