Munchkin Push to Close Gate Manual Del Usuario página 7

How To Install
STEP 5: SETTING YOUR GATE
1. The gap between the gate to the wall should be less than 2.25" (57mm). If necessary,
adjust the lower hinge pin using the wrench to its appropriate length. Then tighten the
nut against the tube by using the wrench.
2. Next, insert the gate's lower hinge pin down into the lower hinge bracket on the wall
until it clicks.
<2.25" (<57mm)
Lower catch
bracket
3. On the catch side of the gate, loosen the nut around
the lower adjustment rod using wrench. Extend the
adjustment rod by turning it clockwise until it is seated in
the lower catch bracket on the wall. (The rod should fully
depress the bracket's center button.) Then, tighten the nut
against the tube by using the wrench.
4. Position the upper hinge pin 1/4"
(6.35mm) from the wall. If necessary,
extend the hinge pin by inserting
the hex key wrench into the end and
turning counterclockwise to create
the 1/4" (6.35mm) gap.
12
Upper hinge pin
<2.25" (<57mm)
Lower
hinge pin
Lower
catch
bracket
Upper
hinge pin
1/4"
6.35mm
STEP 6: INSTALL UPPER HINGE (WALL BRACKET)
1. Slide the upper hinge bracket into
upper hinge pin. Hold the bracket
against the wall so that it's directly
above the lower hinge.
Use the lines of template "A" as a
guide to do this.
Trace the upper hinge bracket's
position with a pencil. Remove
upper hinge bracket and place it aside.
2. Release the lower hinge pin by pushing the hinge lever toward the wall. Then lift the
gate to remove and place it aside.
How To Install
Press hinge
lever
13