Bosch MTS 6520 VCI Manual Original página 36

en 36 | MTS 6520 VCI |
R
If connecting using wireless Ethernet, make sure
that wireless communication is enabled and the IP
configuration is properly set using the VCI Manager
software:
a. Check that the USB cable is not plugged in.
USB connection takes precedence over wireless.
b. Check that the VCI is not being used via wired
Ethernet. Wired Ethernet connection takes pre-
cedence over wireless.
c. Check that the wireless card is properly seated
in the VCI.
d. Contact your IT department and check that
your PC is detecting the wireless access point,
and the correct security settings have been con-
figured for the VCI.
R
If connecting using wired Ethernet, make sure that
wired Ethernet communication is enabled and con-
figured using the VCI Manager software:
a. Check that the USB cable is not plugged in.
USB connection takes precedence over wired
Ethernet.
b. Check that the VCI device detects wired Ether-
net activity by viewing the lights blinking on the
wired Ethernet port of the VCI.
c. Verify that the Ethernet cable is plugged into a
LAN connection such as a router, switch, or hub
and not directly into the PC. The VCI can com-
municate via wired Ethernet with a PC only via a
LAN connection.
R
Contact your IT department for the correct VCI set-
tings.
R
If the VCI Manager is still not able to communicate
with the VCI, perform the Recovery Procedure.
|
1 699 200 077 2017-06-26
10. Cleaning and Maintenance
10.1 Cleaning and Storing Your VCI
The housing of the MTS 6512 module may only be
cleaned using a soft cloth and a neutral cleaning agent.
Do not use any abrasive cleaning agent or rough cleaning
cloths.
i
There are no user serviceable components inside the
MTS 6512 Vehicle Communication Interface. Do not
open the device. Opening the device will void the
warranty.
R
If the VCI, connectors, or cables become dirty, they
may be cleaned by wiping them with a rag lightly
coated with a mild detergent or non-abrasive hand
soap.
R
Do not immerse the VCI or any of its parts or acces-
sories in water.
R
Although the VCI and accessories are water resis-
tant, they are not waterproof; thoroughly dry them
prior to storage.
R
Avoid using harsh solvents such as petroleum based
cleaning agents, Acetone, Benzene, Trichloroethyl-
ene, etc.
10.2 Recovering the VCI Software
As a result of a power failure or a communications error
during a software update, the VCI software may be-
come corrupted. You may see several symptoms such as
error messages directing you to go to RECOVERY mode
or an inability to connect to a detected VCI.
The following two error messages generally occur dur-
ing VCI Tester Software download. If you see either of
these messages, perform the Recovery Procedure.
!
"Error reprogramming the VCI. Go to Recovery
Mode."
!
"There was a problem reprogramming the VCI."
Robert Bosch GmbH