Publicidad
Idiomas disponibles
Idiomas disponibles
1. Install the Faucet
Gasket
Plywood Support
NOTE: Handle orientation is designed to be on the right.
NOTE: For thin gauge stainless steel sinks, consider installing a 1/2" (13 mm)
plywood support (not supplied) between the washer and the sink.
Install the gasket to the faucet with the foam side down.
For Three-Hole Sinks: Place the escutcheon and undercover (sold separately)
over the faucet holes. Insert the faucet, with the handle on the right, through the
escutcheon and the mounting surface.
For Single-Hole Sinks: Insert the faucet through the mounting surface with the
handle on the right.
Partially thread the screws into the ring until they extend 1/4" (6 mm) out the
opposite side.
Slide the washer and ring over the hoses and wires and up to the shank.
Thread the ring onto the shank until the washer contacts the underside of the sink.
Adjust the ring to align the screws with the front and back of the faucet.
Securely tighten the screws.
Kohler Co.
(Optional)
Sold
Separately
Washer
5
1/4"
(6 mm)
Ring
1562954-2-B
Publicidad
